SRY6-2 wind power electric heater is specially designed for heating oil in wind turbine gearboxes. The product is designed according to JBT2379-93 standard, with a simple and practical design. The surface load of the heater is designed to be 1.2W/cm2, made of stainless steel, suitable for use in environments ranging from minus 45 degrees to 90 degrees Celsius.
Read and pay attention to the following:
To ensure correct and reliable use of the electric heater, it must be installed and used by qualified personnel, and the heater must be carefully maintained. Only when used by qualified personnel familiar with the installation, startup, use, and maintenance of similar heaters can the electric heater operate well. Operators must carefully read this instruction manual. The safety instruction manual is included in the accompanying materials of the electric heater, containing relevant safety specifications and effective electrical installation and operation content.
This electric heater is produced and tested according to JBT2379-93 standard. The electric heater has a complete protection device when leaving the factory. To protect and ensure the safe use of the electric heater, users must pay attention to the relevant descriptions in the instruction manual. Failure to follow the instruction manual may result in personal injury or even death, or damage to equipment and facilities connected to the electric heater. In any case, if the content designed in the instruction manual is incorrect, please contact the manufacturer at the address in the following manual. If the electric heater is obviously damaged, faulty, or improperly stored, the electric heater cannot be operated safely.
Standards and Regulations
When used in industries other than those specified in the effective industrial standards or the JBT2379-93 standard noted in the manual, attention should be paid to the same effective standards in the relevant industry.
1.Overview
1.1Description
It is not allowed to use this electric heater above the boiling point of the heating medium at atmospheric pressure.
1.2 SRY6-2 Electric Heater
SRY6 electric heater is used for preheating heavy oil, lubricating oil, diesel, and similar media.SRY6-2 maximum working temperature 100°C, maximum use temperature must not exceed 300°C. The user can increase or decrease the number of heaters according to the quantity of heating medium, heating time, and temperature rise limit.
1.3 Since the heating tubes are arranged in a fluid manner, the heater can heat the heating medium very evenly. The replaceable electric heating tubes are inserted into the heater container. When replacing the heater, there is no need to drain the heated medium.
1.4 If the surface load of the selected heater is low, it can avoid bubbles and carbonization of the heating medium.
1.5 Main components of the heater:
Flange, wiring cover, electric heating tube, heater seal, cable lock, etc. For special forms of heaters, please provide details of the accessory data.
