Hot Press Mold Oil Heater, Thermal Oil Heater, Mold Temperature Controller
Hot Press Mold Oil Heater, Thermal Oil Heater, Mold Temperature Controller adopts a microcomputer control system, combined with dual P.I.D designed temperature controller, and Schneider electric components, using high-quality electrical components, making the oil temperature machine outstanding in terms of service life and failure rate among similar products. Consultation hotline: (188 1766 7889)
Hot Press Mold Oil Heater, Thermal Oil Heater, Mold Temperature Controller function introduction:
1. Temperature controller: Omron automatic calculation type, PC-level microcomputer circuit board, strong combination to create precision machines;
2. Electrical components: French industrial pioneer brand - Schneider electric components;
3. Circulation pump: Taiwan high-quality high-temperature pump, strong pump pressure, stable operation, and quiet;
4. Appearance design: Won multiple patents, the electrical box and body are designed with 10mm separation to isolate hot air and moisture, effectively extending the service life of electrical components;
5. Circuit design: Interlocking error-proof circuit and practical fault indication, fully protect the stable operation of the mold temperature machine;
6. Piping design: Made of 304 stainless steel seamless pipe in one piece, small pipe loss, uniform heating, and can reduce the thermal decomposition reaction of the medium, reducing the generation of scale or oil sludge;
7. Heating tube: Swedish imported heating inner wire, specially extended type, reduces the load per unit area, extends its service life, very low damage rate, through microcomputer automatic segmented heating method, temperature adjustment is more stable and more energy-saving.
Hot Press Mold Oil Heater, Thermal Oil Heater, Mold Temperature Controller maintenance suggestions:
After purchasing a new hot press mold oil heater, before use, please check whether the thermal oil is circulating to prevent damage to the thermal oil heater due to insufficient thermal oil. We should keep the working environment of the mold temperature controller clean to avoid dust, which can greatly extend the service life. According to the operating temperature, replace the thermal oil regularly. For temperatures above 200°C, replace it every half year; for temperatures below 200°C, replace it about once a year, thus avoiding the problem of not reaching the temperature. In terms of piping, we should judge whether there is blockage in the pipeline based on the relationship between pump and pressure. If the pressure is too low, we can remove the heating tube and clean it with tools, especially the filter mesh at the system inlet, clean it once a month. Regularly check whether the oil pump of the thermal oil heater is leaking oil. If necessary, the pump shaft seal can also be replaced regularly.
